Guide · AT-R19REV. 2026-A

The computer won't start: narrow it down instead of guessing

“It won't switch on” can describe five very different problems. Spending a few minutes watching what happens at startup is more useful here than running diagnostic software.

By Benjamin ReichertNetworks, hardware, support · IT specialist for system integration (Fachinformatiker, IHK)Last updated:

A computer starts in stages. It gets power, checks its hardware and then loads the operating system. Watching where it stops helps you narrow down the cause without tools.

How far does it get?

Nothing at all. No light, no fan noise, nothing. That is a power problem, not a Windows problem.

It powers up, but the screen stays black. Fans spin, lights are on, but there is no picture. Something is wrong between the computer and the screen, or it does not get past the hardware check.

Manufacturer logo, then it stops. It has checked the hardware and is looking for the operating system. From here on it is usually software.

Windows logo, then a restart or a blue screen. Windows starts loading and then fails. A driver, an update or file system damage is almost always the cause. If the screen shows a stop code, the blue screen guide explains it and lists the steps in order.

HOW FAR DOES IT GET?PowerPower supplySocketHardware checkMemoryScreenBoot processUSB stick plugged inBoot orderWindowsDriver, updateFile system→ stop here

If nothing happens at all

On a laptop: unplug the power adapter, remove the battery if it is removable, then hold the power button for thirty seconds. That discharges the residual charge, and a surprising number of devices start again afterwards.

On a desktop, start with the basics. Is the power supply switch set to I? Is the cable connected at both ends? Is everything plugged into a power strip with its own switch? That is a frequent culprit, because it is easy to switch off without noticing.

Next, try a different power supply or wall socket. If the problem persists, it points to a hardware fault and there's little to gain from further attempts.

The computer starts but the screen stays blank

Check the monitor first. Is it on, is the right input selected, and is the cable seated firmly? Try a different cable or port.

A desktop computer has one extra quirk. If there is a graphics card, the screen cable must go into that and not into the motherboard. This is one of the cases where everything runs and yet nothing can be seen.

On a laptop, try two keyboard shortcuts before looking further. Windows key + P changes where the output goes. If the laptop is still set to use a projector from your last presentation, its own screen may stay dark. Windows key + Ctrl + Shift + B restarts the graphics driver. Both shortcuts need Windows to be running. One clue is that the laptop quietens down after startup.

Windows won't start

Unplug all USB devices except the keyboard and mouse. A flash drive or an external disk can cause the computer to look for the operating system in the wrong place. This accounts for a surprising number of startup problems.

If that doesn't help, let Windows finish one automatic repair. Allow it to complete, even if it takes a long time.

The point at which you should stop

Repeatedly switching off by force in the middle of start-up damages the file system. A problem that a professional solves in half an hour turns into a case for data recovery.

Be careful with online guides that tell you to format the drive or reset the computer. You could lose your data.

If the device holds something you need and the steps above have not helped: switch it off and leave it. Take photos of any error messages that appear. They often let us say over the phone what the cause is. What a call-out costs is in the price list.

If the drive makes clicking or grinding noises, switch the computer off immediately. Our guide “Hard drive failed” explains why.

Common questions

My laptop charges but won't switch on. Is the battery to blame?

Possibly, but check the power adapter first. A charging light only tells you that power is arriving, not that enough is. An underpowered third-party adapter charges slowly but is not enough to start the laptop. Using the original or one with the same wattage is no minor detail here.

I hear a beep when I switch on. What does it mean?

The beeps are a motherboard error code. The meaning depends on the manufacturer. Count the beeps and write down the pattern of short and long tones. We can often narrow down the cause over the phone and save you a trip.

Windows repairs itself after the third failed start. Should I let it run?

Yes, letting the automatic repair run through once is fine. What you should not do is cancel it repeatedly because it takes too long. Some checks take an hour or more on large drives, and cancelling halfway through can damage the file system.

Can I save my data if Windows no longer starts?

In most cases, yes. As long as the drive itself is intact, it can be removed and read on another computer. That is why it matters so much not to overwrite anything beforehand. If the drive is encrypted, we need the recovery key from your Microsoft account for this.

Is a repair worth it, or should I buy a new device straight away?

It depends on which part has failed. Replacing a power supply or an SSD is manageable and almost always worth it. If the motherboard fails, or the display on a laptop, the parts quickly cost half the price of a new device. We'll tell you that before we start, even if we'd earn more from the repair.

+49 3744 4399760Mon–Fri 8:00–17:00
CallCallback

PARTS LIST · SHEET 1/1

What this page is made of

Values measured at build time. With JavaScript, your browser measures them again live.

ITEMPARTTYPESIZE
01index.htmlDocument≈ 29 kB
02styles.cssStylesheet≈ 20 kB
03scripts.jsScript≈ 13 kB
04archivo-variable.woff2Font≈ 58 kB
05ibm-plex-mono.woff2Font≈ 30 kB
06favicon.svgImage< 1 kB

Advertising or analytics cookies: none. Without your consent, the page loads nothing from third-party servers apart from Cloudflare, our delivery service. Fonts, scripts and images are hosted by us. That is how we build your IT, too.

OUTSIDE OFFICE HOURS

Feel free to call anyway

Our regular office hours are Monday to Friday, 8:00–17:00.

In the evening and at weekends the number is forwarded to us, and often someone will pick up. We cannot promise that, though.

If nobody answers, leave a short message on the voicemail: your name, your number and what it is about. We will call back as soon as we can, on the next working day at the latest.

The call costs nothing. If someone has to start work straight away outside office hours, the surcharge in the price list applies.

Call now+49 3744 4399760

Prefer to write? Use the contact form or e-mail [email protected]. We will read it on the next working day.

DIAGNOSIS · AT-K2

What do you need help with?

↵ SELECTESC CLOSECALL: +49 3744 4399760

Custom settings

Which services may load?

Strictly necessary

The choice you make here and your settings for colour scheme and motion. These are kept as small entries on your device and are never sent to a server. They are needed for the site to work and therefore cannot be switched off.