Guide · AT-R33REV. 2026-A

Laptop getting loud and hot: what causes it

The fan spins up, the palm rest gets warm, and after half an hour everything starts to stutter. That does not mean the device is broken. It simply cannot keep up with the heat any more.

By Benjamin ReichertNetworks, hardware, support · IT specialist for system integration (Fachinformatiker, IHK)Last updated:

A laptop packs a lot of processing power into very little space. Its cooling system consists of a fan, a finger-thick heat pipe and a stack of fins the size of a matchbox. A restriction in that path lets heat build up. The processor slows down to protect itself and the fan speeds up to shed more heat. That is the noise you hear.

First, pin it down: when does it spin up?

Answer this before reaching for a screwdriver. It quickly narrows down the cause.

Only when switching on, for a few seconds. That is a self-test. If it goes quiet again afterwards, there is nothing to do.

Only under load. A video conference or a large Windows update. A thin device may be loud then. Annoying, but down to the design.

Constantly, even when you are doing nothing. Something is wrong. Either a program is working in the background or the cooling is blocked.

Only after twenty to thirty minutes, and then everything gets sluggish. That is the classic heat build-up.

Second question: loud, hot or both? Loud but only lukewarm means the fan is working and the heat is getting out. Hot and strikingly quiet is the worse sign: the heat is not even reaching the fan. Both together is the normal case on our workbench.

The most common causes

The cooler is blocked. The fins sit right at the outlet, and for years the fan pushes room air through them. Dust and hair settle on the inside of the fin stack as a felt-like mat. After three to five years that is not the exception but the rule.

The thermal paste has dried out. Between the chip and the cooler sits a wafer-thin layer of paste that bridges the last air gap. After about five years it is hard and crumbly. The device can then be clean inside and still get hot.

The fan bearing has failed. A fan that grinds, rattles or clicks rhythmically has a mechanical problem, not a dust problem. Cleaning will not change that; the part has to be replaced. For common models, a replacement fan is usually still available.

A program is creating constant load. A cloud sync that never finishes, or a supposed optimisation tool. The fan is then doing exactly the right thing; the cause simply lies elsewhere. What typically runs in the background is covered in the guide “PC is slow”.

The surface underneath. On almost all laptops the air intakes are on the underside. A device on a duvet or on the sofa is standing on a sponge and gets no air. This is the only cause in this list that you can fix in five seconds. If you work at a laptop every day, you will find desk height and distance in the screen workstation calculator.

FANHEAT PIPEFINSIntake underneathAir from outsideit clogs up hereDust and hairOutlet

What you can check yourself in ten minutes

  1. Change the surface. A hard, flat surface, and a few millimetres of air under the rear edge. Two corks will do.
  2. Shine a torch into the vents, underneath and at the side outlet. Grey fluff between the fins is unmistakable.
  3. Open Task Manager (Ctrl + Shift + Esc / Strg + Umschalt + Esc), “Processes” tab, sort by CPU. If something there sits at thirty per cent or more while idle, you have found your cause. Updates and the virus scanner may be at the top briefly, but not for hours.
  4. Turn the power mode down. In Windows 11, go to Settings, “System”, then “Power & battery”; in Windows 10 it is called the power plan. That costs a little speed and takes a lot of work off the fan.
  5. Restart and watch for half an hour to see whether anything changes.

If that does not make it better, it is hardware.

Why compressed air rarely helps with a laptop

The can from the electronics shop is the obvious thing to reach for, and with a laptop it is usually the wrong answer. The felt sits on the inside of the fin stack. If you blow into the outlet from outside, you push it deeper into the device instead of out. With an open desktop PC the can works; with a laptop it does not.

On top of that, the fan spins freely and faster than it was built to. The bearing does not take that well. And if you hold the can at an angle, you spray liquid propellant onto the circuit board.

That leaves opening it yourself. With a business laptop that has a service hatch, that is manageable. On most thin devices the cooler lies under the mainboard: keyboard out, board out, everything back in again. What breaks is rarely the screws, but the clips on the edge of the case and the ribbon cables of the touchpad and keyboard. Their connectors have tiny hinged locking flaps that snap off if you pull on the cable instead of opening the flap. A torn touchpad cable costs more than the whole cleaning.

What we do

Take the device apart, remove the cooler, clear the fin stack from the inside. Remove the old paste from the chip and the base of the cooler, apply new paste, reassemble. We check the fan while we are at it: if it runs smoothly, it stays. If it rattles, a new one goes in. That is decided when we open it up, not beforehand on the phone.

We then run the laptop under full load and check its temperature to see how much the service helped.

Allow for one working day during which the device stays with us; longer if a fan has to be ordered first. What it costs depends on the effort and the spare part. We give you the range beforehand, and the hourly rates are on the price page.

When it is not a cooling problem at all

Swollen battery: stop using it at once

If the device wobbles on the table, the bottom case bulges or the touchpad sticks and can no longer be clicked, the battery is very probably swollen. In that case: stop using it and do not charge it under any circumstances. Unplug the charger, place the device on a non-flammable surface, do not press on the bulge and do not drill into anything.

A swollen lithium battery can catch fire, and that fire cannot be put out the way a paper fire can. Bring the device to us or to the recycling centre. What should happen to your data beforehand is covered in the guide “Old PC to be disposed of”.

The power adapter. A power adapter gets warm in use; that is normal. But it should not get hot, and certainly should not smell. Strikingly often, this affects cheap copies without a safety mark.

The graphics chip. If the device gets hot and shows stripes or blocks on the screen, or freezes, the graphics chip may be the cause. It is soldered on, and that usually means the end of a repair that makes economic sense. We will tell you so, rather than sell you a cleaning that changes nothing.

Is it still worth it?

Cleaning including new paste costs a fraction of a new device. The question is still a fair one, and it comes down to three points.

Condition and age. Up to about seven years, and if hinges, screen and battery are in order, the answer is clear: have it done.

Windows 11. If the processor is not approved for it, security updates are only available through the free ESU programme until mid-October 2027. What options remain after that is covered in the guide “Windows 10 is no longer supported”.

What else is due. Cleaning plus battery plus a wobbly hinge on an eight-year-old entry-level device: that is where it stops. In that case we would rather talk about a suitable new device than about a repair that does not pay off. You will hear that from us beforehand, even though we earn nothing from that advice. How good the battery still is, the battery check shows you beforehand.

Common questions

How often does a laptop need cleaning inside?

As a rough guide, every two to three years. With carpets or pets, aim for every two years. You can also tell from the fan: it becomes audible all the time, even when the laptop is idle.

Is cleaning enough, or does the thermal paste always have to be replaced too?

Replace the thermal paste if you remove the heatsink from the chip. Once lifted, the old layer can no longer make even contact when you refit the heatsink. You can leave the paste in place if a service hatch lets you clean the cooling fins without removing the heatsink.

Can the heat destroy my data?

The processor slows itself down and, if it comes to it, shuts off before it is damaged. The greater danger is a sudden shutdown in the middle of writing data, because that can corrupt files. So make sure you have a backup before you keep using a hot device.

Does a laptop cooling pad underneath help?

A little, provided the device would otherwise be standing on a soft surface. It does not help against clogged fins: it just pushes air against a blocked path. A few millimetres of air under the rear edge do almost the same and cost nothing.

Straight after switching on, the fan runs flat out for a moment. Is that a bad sign?

No. Many devices spin the fan up once at start-up to check that it runs. If it goes quiet again afterwards, everything is fine. It only becomes a concern if it stays up.

+49 3744 4399760Mon–Fri 8:00–17:00
CallCallback

PARTS LIST · SHEET 1/1

What this page is made of

Values measured at build time. With JavaScript, your browser measures them again live.

ITEMPARTTYPESIZE
01index.htmlDocument≈ 29 kB
02styles.cssStylesheet≈ 20 kB
03scripts.jsScript≈ 13 kB
04archivo-variable.woff2Font≈ 58 kB
05ibm-plex-mono.woff2Font≈ 30 kB
06favicon.svgImage< 1 kB

Advertising or analytics cookies: none. Without your consent, the page loads nothing from third-party servers apart from Cloudflare, our delivery service. Fonts, scripts and images are hosted by us. That is how we build your IT, too.

OUTSIDE OFFICE HOURS

Feel free to call anyway

Our regular office hours are Monday to Friday, 8:00–17:00.

In the evening and at weekends the number is forwarded to us, and often someone will pick up. We cannot promise that, though.

If nobody answers, leave a short message on the voicemail: your name, your number and what it is about. We will call back as soon as we can, on the next working day at the latest.

The call costs nothing. If someone has to start work straight away outside office hours, the surcharge in the price list applies.

Call now+49 3744 4399760

Prefer to write? Use the contact form or e-mail [email protected]. We will read it on the next working day.

DIAGNOSIS · AT-K2

What do you need help with?

↵ SELECTESC CLOSECALL: +49 3744 4399760

Custom settings

Which services may load?

Strictly necessary

The choice you make here and your settings for colour scheme and motion. These are kept as small entries on your device and are never sent to a server. They are needed for the site to work and therefore cannot be switched off.